GN3021DX
Features and Benefits
  • The GN3021DX Thermoformer was developed to meet the demand for thermoformed APET products. It was designed to provide greater APET cutting capacity than the standard
  • Contact-Heat Cut-In-Place GN3021C Thermoformer
  • In-mould cutting ensuring consistent and accurate trim
  • Servo-driven platen for smooth and energy efficient movement
  • Four point toggle systems with oversized roller bearings
  • High speed forming system
  • Multi-zone contact heating system
  • Electric pre-heater
  • Microprocessor-based control systems (PLC)
  • Photo scanning available for preprinted sheet
  • Static eliminator
  • Stacking equipment available
GN Tooling
  • Cost effective tooling is designed, manufactured and production tested at our facility
Forming Area 760mm x 530mm (30" x 21") maximum
Depth of Draw 125mm (5") maximum
Clamping Force 100 Ton
Sheet Width 815mm (32") maximum
Material Thickness Range 0.15mm - 1.00mm (0.006"-0.040")
Material Roll Diameter 711mm (28") maximum
Dry Cycles per Minute 30 maximum
Main Supply Voltage 3x400V+N+PE, 50-60Hz (380-415V) / 3x480V+PE, 50-60Hz (440-480V) / 3x220V+PE, 50-60Hz (220-240V)
Power Consumption 7.5 Kilowatts/hr (Approximate)
Air Pressure 6.8 bar (100 PSI) minimum
Air Consumption 1315 Litres/min (48 CFM)
Machine Dimensions (l x w x h) 2895mm x 1850mm x 2160mm (114" x 73" x 85")
Knife Length (maximum) 8500mm (335") for APET / 9525mm (375") for other thermoformable materials
Cooling Water Consumption 6 Litres/min @ 15C - 20C) (1.5 gal/min @ 58F - 68F)
Machine Weight 3420 kg (7540 lbs)
Menu Item

Menu Item

Menu Item


Excellent reliable equipment and very knowledgeable technical service department. Excellent parts department with most things I need in stock....

William Szablewski | Tomric Systems, USA

tradeSHOWS
ourPRODUCTS
ourSERVICES
contactUS
© 2018GN Plastics | Thermoforming Machines
Website Design by Amplify Media